
WeSee · Spot-Sprayer Retrofit
Stop spraying where treatment is not needed.Start spot-spraying with up to 80% less herbicide or fertiliser.
WeSee adds cameras and AI to the sprayer boom you already own.
- Existing sprayer boom
- Camera + on-board AI
- Individual nozzle control
- No GPS required
- Works without internet in the field
Broadcast vs. WeSee
Pay for the weeds, not the whole field.
The same field, sprayed two ways.

Broadcast spraying
- The whole boom sprays the whole field.
- Only a small share hits a weed.
- The rest lands on soil and crop — and you pay for all of it.
With WeSee
- The camera tells crop from weed, plant by plant.
- Only the nozzle above a weed sprays.
- Nozzles stay closed over soil and crop.
Up to 80%less herbicideDepending on crop, weed pressure and field conditions.
How it works
How WeSee decides where to spray.
Cameras on your boom watch the field as you drive. On-board AI decides, plant by plant, where spraying is needed — and only those nozzles open.
Step 01
See
Cameras on the boom watch crops, weeds and soil as you drive.
Step 02
Decide
On-board AI tells crops from weeds and decides where to spray — in real time, without an internet connection.
Step 03
Act
Each nozzle opens only where treatment is needed and stays closed over bare soil.
Step 04
Monitor
Images, detections and sprayed areas are saved in WeMan, so you can review every pass.
Step 01
See
Cameras on the boom watch crops, weeds and soil as you drive.
Step 02
Decide
On-board AI tells crops from weeds and decides where to spray — in real time, without an internet connection.
Step 03
Act
Each nozzle opens only where treatment is needed and stays closed over bare soil.
Step 04
Monitor
Images, detections and sprayed areas are saved in WeMan, so you can review every pass.
Camera installation
Give your sprayer boom smart eyes.
WeSee adds a camera on top of your existing boom and a WeSee module on every nozzle below it. One camera watches 2.5 m of working width and talks to its nozzles wirelessly.


Step 1: Mount the camera on the boom.
Bolt the camera bracket onto the top of the boom.

Step 2: Fit a WeSee module on every nozzle.
Each nozzle under the camera gets its own module, fitted in three quick steps.
See the three steps
Watch the full installation.
The camera goes onto the boom, WeSee modules go onto the nozzles, and camera and nozzles connect wirelessly.
- One camera covers 2.5 m of working width.
- That is 10 nozzles at 25 cm spacing, or 5 at 50 cm.
- Camera and nozzles connect wirelessly.

Nozzle modules
Then a WeSee module on every nozzle.
Each module sits between the nozzle body and the nozzle cap already on your boom. Take the cap off, twist the module on, put the same cap back.

- Nozzle body
- WeSee module
- Nozzle cap

Step 1: Remove the original nozzle cap.
Unscrew the cap from the nozzle body on the boom. Keep it — it goes back on in step 3.

Step 2: Fit the WeSee module.
Twist the module onto the nozzle body, where the cap used to sit.

Step 3: Refit the original nozzle cap.
Twist the same cap onto the bottom of the module. Done.
Watch all three steps in 24 seconds.
Remove the nozzle cap, twist on the WeSee module, put the cap back.
One power cable. Everything else is wireless.
Book a free demo
Operating modes
Choose how your sprayer applies treatment.
Pick one of five modes for each job: spray only the crop, only the weeds, all green plants or the whole area — or switch nozzles by hand.
Select a mode to see it in action.
- No GPS required
- Works without internet in the field
WeSee in the field
See WeSee spraying in the field.
Real footage from a field trial — the same tractor and the same boom, now opening each nozzle only where treatment is actually needed.

Economics
How much could WeSee save in one spraying season?
Enter your herbicide and fertiliser cost for one spraying season to see your estimated saving with WeSee.
Estimate your own benefit
Start with one number. The first result appears immediately.
Step 1 of 2
How much do you spend on herbicide and fertiliser in one spraying season?
Include the products you apply with your sprayer.
Who it's for
For sprayer owners — and the partners who serve them.
WeSee is for farms that want to stop spraying the whole field and spray only where it is needed, without buying a new sprayer. Contractors, dealers and sprayer manufacturers can offer it too.
Sprayer owners
This is you if: you already run a working sprayer boom and want to add spot-spraying.
Standard & wide booms
Add spot-spraying to a boom that already applies herbicide or fertiliser — without replacing your current sprayer.
Smaller booms, from 12 m
WeSee also suits smaller booms of around 12 m, where saving input still makes a real difference.
Partners & integrators
This is you if: you want to bring targeted spraying to your customers — or build our AI vision into your sprayers.
Contractors, dealers & service partners
Bring targeted spraying to customers as a practical retrofit. WeSee supports service models, dealer networks, and machines already in use.
Sprayer manufacturers & OEMs
Build the AI vision behind WeSee into your own sprayers and spot-spraying systems.
Best fit — when customers want spot-spraying without buying a new machine, or a sprayer manufacturer needs reliable plant detection.
Start with your current sprayer.
WeSee is built for retrofit. Share your sprayer setup with us, and we will check whether spot-spraying with WeSee is a good fit.
Questions
Questions about WeSee.
Does WeSee replace my sprayer?
No. WeSee is a retrofit system. It is added to the sprayer boom you already use.
Does WeSee work only on large sprayer booms?
No. Smaller booms of around 12 m can be a good fit too, as long as saving input matters to you.
Does WeSee need GPS?
No. WeSee's cameras and on-board AI see the plants directly, so no GPS is needed.
Does WeSee need a cloud connection during spraying?
No. All AI decisions are made on the sprayer itself, so WeSee works without an internet connection in the field.
What can WeSee apply?
Herbicide, fertiliser or crop protection products. The operating mode you choose decides where they are applied.
How much input can WeSee save?
WeSee can reduce herbicide or fertiliser use by up to 80% compared with blanket spraying, depending on crop, field conditions, weed pressure, and use case.
Can contractors or dealers use WeSee?
Yes. WeSee can support service models, dealer networks, and customer machines that are already in use.
Can sprayer manufacturers or technology partners use the AI vision behind WeSee?
Yes. The AI vision behind WeSee can be built into sprayers and other spot-spraying systems.
How quickly does WeSee pay for itself?
It depends on how much you spend on herbicide and fertiliser and how wide your boom is. WeSee can cut that input by up to 80%, so the higher your yearly input cost, the faster it pays back. The calculator on this page gives you an estimate — not a guaranteed saving.

Next step
Ready to move from blanket spraying to spot-spraying?
Start with the sprayer you already use. We will check whether WeSee is a good fit for your setup and your spraying goals.